Open in the HutScanner map

Rifugio Serafino Gnutti

2183 m · sleeps 34 · Adamello & Presanella · IT

You can walk to 6 huts from here in a day, listed below with times and grades, and we read the calendars of 14 huts in this network daily, so a multi-night route through here can be checked night by night.

Rifugio Serafino Gnutti is an alpine hut at 2183 m in the Adamello & Presanella, IT. 6 other huts can be reached from here on foot in a day.

How to book

You book Rifugio Serafino Gnutti directly with the hut. HutScanner is a planning tool and does not take bookings or hold beds.

Open the hut's booking page

Or contact the hut directly: [email protected], +39 0364 72241.

Walkable from here

Times are estimates for an average fit hiker - terrain and conditions vary. Grades are the SAC hiking scale, judged the way the app judges them: the hardest ground that runs far enough to characterise the leg.

Plan a route from this hut

See the whole Adamello & Presanella network

About Adamello & Presanella

58 huts connected by 1317 walking routes in the Adamello & Presanella massif.

Planning a route through Rifugio Serafino Gnutti

Booking one hut is the easy half. The work is the chain: every night needs a bed, at a hut you can walk to from the one before, on consecutive dates, and one full night sends you back to the start. From Rifugio Serafino Gnutti there are 6 onward huts within a day's walk, listed above, inside an Adamello & Presanella network of 58 huts. HutScanner searches that network for a sequence that works on your dates, rather than leaving you to try the huts one at a time.

Rifugio Serafino Gnutti books online but publishes no calendar HutScanner can read, so a route through it is planned around the 14 huts in Adamello & Presanella that do publish one, and this night is confirmed with the hut itself. Plan a multi-night route from Rifugio Serafino Gnutti.

If you plan trips through ChatGPT or Claude, they can run this same search for you without opening the app, over the regions HutScanner has reviewed by hand. How that works is described in using HutScanner with AI assistants, and the endpoint is documented in the OpenAPI spec.