Open in the HutScanner map

Eisenkappler Hütte / Kapelska koča

1555 m · Julian Alps & Karavanke · AT

You can walk to 2 huts from here in a day, listed below with times and grades, so this hut can be a link in a longer walk.

Eisenkappler Hütte / Kapelska koča is an alpine hut at 1555 m in the Julian Alps & Karavanke, AT. 2 other huts can be reached from here on foot in a day.

How to book

You book Eisenkappler Hütte / Kapelska koča directly with the hut. HutScanner is a planning tool and does not take bookings or hold beds.

Open the hut's booking page

Or contact the hut directly: [email protected], +43 664 4312824.

Walkable from here

Times are estimates for an average fit hiker - terrain and conditions vary. Grades are the SAC hiking scale, judged the way the app judges them: the hardest ground that runs far enough to characterise the leg.

Plan a route from this hut

See the whole Julian Alps & Karavanke network

About Julian Alps & Karavanke

149 huts connected by 1458 walking routes in the Julian Alps & Karavanke massif.

Planning a route through Eisenkappler Hütte / Kapelska koča

Booking one hut is the easy half. The work is the chain: every night needs a bed, at a hut you can walk to from the one before, on consecutive dates, and one full night sends you back to the start. From Eisenkappler Hütte / Kapelska koča there are 2 onward huts within a day's walk, listed above, inside a Julian Alps & Karavanke network of 149 huts. HutScanner searches that network for a sequence that works on your dates, rather than leaving you to try the huts one at a time.

Eisenkappler Hütte / Kapelska koča books online but publishes no calendar HutScanner can read, so a route through it is planned around the 0 huts in Julian Alps & Karavanke that do publish one, and this night is confirmed with the hut itself. Plan a multi-night route from Eisenkappler Hütte / Kapelska koča.

An AI assistant can run the same search without opening the app, over the regions HutScanner has reviewed by hand: see using HutScanner with AI assistants for the endpoint and the OpenAPI spec.