Open in the HutScanner map

Armelenhütte

1747 m · Otztal & Stubai Alps · AT

You can walk to 4 huts from here in a day, listed below with times and grades, and we read the calendars of 33 huts in this network daily, so a multi-night route through here can be checked night by night.

Armelenhütte is an alpine hut at 1747 m in the Otztal & Stubai Alps, AT. 4 other huts can be reached from here on foot in a day.

How to book

You book Armelenhütte directly with the hut. HutScanner is a planning tool and does not take bookings or hold beds.

Open the hut's booking page

Or contact the hut directly: [email protected], +43 664 2002590.

Walkable from here

Times are estimates for an average fit hiker - terrain and conditions vary. Grades are the SAC hiking scale, judged the way the app judges them: the hardest ground that runs far enough to characterise the leg.

Plan a route from this hut

See the whole Otztal & Stubai Alps network

About Otztal & Stubai Alps

77 huts connected by 260 walking routes in the Otztal & Stubai Alps massif.

Planning a route through Armelenhütte

Booking one hut is the easy half. The work is the chain: every night needs a bed, at a hut you can walk to from the one before, on consecutive dates, and one full night sends you back to the start. From Armelenhütte there are 4 onward huts within a day's walk, listed above, inside an Otztal & Stubai Alps network of 77 huts. HutScanner searches that network for a sequence that works on your dates, rather than leaving you to try the huts one at a time.

Armelenhütte books online but publishes no calendar HutScanner can read, so a route through it is planned around the 33 huts in Otztal & Stubai Alps that do publish one, and this night is confirmed with the hut itself. Plan a multi-night route from Armelenhütte.

If you plan trips through ChatGPT or Claude, they can run this same search for you without opening the app, over the regions HutScanner has reviewed by hand. How that works is described in using HutScanner with AI assistants, and the endpoint is documented in the OpenAPI spec.